PRODUCT DESCRIPTION
Fits: B/RB & HEMI
HEAVY DUTY ELECTRIC CENTER SECTION - 100 SERIES WITH HIGH PRESSURE PORT
American made with quality far superior to any other performance aftermarket company, we build our water pumps with pride right here in the USA. Our 2 year, unlimited mileage guarantee and full satisfaction money back guarantee should convince you that buying Meziere is buying value! If you feel the need to carry a spare or replace a worn out pump, we can address that with our replacement center sections. These are easy, drop in units that fit most of our 100 series pumps and can be installed in just minutes.
This water pump model features:
Fits big block Mopar B/RB/Hemi engines
Reservoir design eliminates cavitation and air locking
High and low pressure #6 ports ready to use with our heat exchanging trans pan
Suitable for street or drag strip use – 3000+ hour life expectancy
Show quality finish
Heavy duty motor provides 42 gallons per minute free flow rating
Heavy duty motor provides 3000+ hour life expectancy
All stainless steel hardware included
Light weight. Complete standard big block Mopar unit weighs only 9.5 pounds!
Stainless steel large diameter main shaft with high performance ceramic seal
Pump will clear cam belt drives and most blower drives
1" NPT inlet adapters are available for #12AN, #16AN, #20AN, 1¼", 1½" or 1¾" slip hose
Belt Drives: Standard BBM design will clear Jesel belt drives and comparable belt drive systems.
Distributer Belt Drives: Spacers will be necessary to clear belt drive distributor systems.
Finishing The System: This pump is supplied complete with gaskets and hardware but without the inlet fitting. The fitting needs to be ordered according to the size of the lower radiator hose.
Amperage draw: Under normal use the pump will draw 6-7 amps.
Overall Height Dimension: The standard pump is 7.5" long from the mounting surface to the tip of the pump.
Pump Weight: This application weighs 9.5 lbs.
16 volt systems: The 12 volt pump will work for limited use applications. The pump should not be powered while charging your 16 volt system.
Additional Notes: The standard 35 GPM pump is suitable for normally aspirated engines up to 650HP. In drag-only, towed applications it is appropriate to 1800 HP. Supercharged, Turbocharged and high compression, high horsepower applications should use the 55GPM High Flow pump.
