Engine harness

Fits: 1973 Plymouth & Dodge E-Body Models

This is a 2 piece harness connected in the valve cover area by a 8 way connector and a 2 way connector. This harness has the factory style non-adhesive vinyl wrap tape covering the wires. It contains the following: 8 way connector to firewall bulkhead. Single connector with lead for brake test equipment (This was a government mandated addition to all cars. It is a connector that federal inspectors could attach a testing device to, and check the brake warning light system). Single connector with lead to proportioning valve for brake warning light. Two 2 way connectors with leads to ignition ballast resistor. 5 way connector with leads to electronic ignition control box. 2 way connector with circular retainer and lead to voltage regulator. Square style clip to position harness. Ring terminal with lead to positive side of ignition coil. Ring terminal with lead to negative side of ignition coil. 2 way connector with lead to distributor magnetic pickup. Terminal with lead to oil pressure sending unit. Single connector with lead to electric choke. Single connector with lead to temperature gauge sending unit. 2 single connectors with leads and a ring terminal with boot and lead to alternator. Single connector with lead to windshield washer pump motor