Fits: B/RB & HEMI water pump housings

Pump Material: Aluminum

Pump Color: Black

Hose Adapter Required: No

Hose Adapter Included: No

Amp Draw: 9.00 amps

Remanufactured: No

Quantity: Sold individually.

Notes: Motor can flow upwards of 50 gph but will depend on what housing is used.

 

PRW High-Flow Diecast Electric Water Pumps

PRW high-flow diecast water pumps will fulfill your cooling needs, without draining horsepower from your engine. They feature heavy-duty motors that turn at approximately 1,500 rpm, draw only 6 to 7 amps, and will flow at 35 gpm. PRW high-flow diecast water pumps are offered for several applications, available in a chrome or black powdercoat finish, and include gaskets, billet aluminum inlet fitting, mounting hardware, pigtail connector, and timing cover block-off plate (where applicable).

Additional features:

* Lightweight
* Suitable for street or strip
* 2,750 hours of continuous operation at 176 degrees F
* Pump will clear most timing belt drives and most blower drives
* Some applications are available with or without backing plates

 

This alternator plug-pigtail incorporates a Weather Pack style seal and an in-line resistor that allows, but does not require, a charge light in this exciter circuit. The exciter wire is blacked out as it leaves the alternator plug, so that little bit of wire going into your flex loom isn't as noticeable. Features: In-line 560 ohm, 1/2 watt resistor that allows but does not require a charge light 8 ft. length Fits GM alternators with a 4 Pin oval connector Needs to be terminated to a switched 12v source that is "on" while the engine is running. Weather Pack style seal Connector Color Black Connector Gender Male Connector Quantity 1 Emission Code 5 Finish Yellow Grade Type Performance Material Wire Part Type Alternator Harness Product Type Pigtail Connector Sub Category Alternator / Generator and Related Components Warranty Manufacturer's Limited 90 Day Warranty Wire Quantity 1 Wiring Harness Length 8 FT

Aluminum Saginaw power steering pump for use on Low-Mount LS Accessory Drive. Includes reservoir.

Features: Aluminum Housing Bearing Supported Shaft Includes Integrated Reservoir 0.66” Shaft Diameter .88 GPM at 465 RPM Low Flow 2.8 GPM at 1500+ RPM. 1100-1200 PSI 

Specs 

Filter Included No
Finish Cast
Grade Type Performance
Housing Material Aluminum
Inlet Attachment Type Barb
Inlet Quantity 1
Material Cast Aluminum
Mounting Hardware Included No
Outlet Attachment Type Threaded
Outlet Quantity 1
Part Type Power Steering Pump
Product Type Power Steering Pump
Pulley Attachment Type Press-On
Pulley Included No
Remote Reservoir No
Remote Reservoir Included No
Reservoir Cap Included Yes
Reservoir Included Yes
Shaft Type Press-On 

This alternator plug-pigtail incorporates a Weather Pack style seal and an in-line resistor that allows, but does not require, a charge light in this exciter circuit. The exciter wire is blacked out as it leaves the alternator plug, so that little bit of wire going into your flex loom isn't as noticeable. Features: In-line 560 ohm, 1/2 watt resistor that allows but does not require a charge light 8 ft. length Fits GM alternators with a 4 Pin oval connector Needs to be terminated to a switched 12v source that is "on" while the engine is running. Weather Pack style seal Connector Color Black Connector Gender Male Connector Quantity 1 Emission Code 5 Finish Yellow Grade Type Performance Material Wire Part Type Alternator Harness Product Type Pigtail Connector Sub Category Alternator / Generator and Related Components Warranty Manufacturer's Limited 90 Day Warranty Wire Quantity 1 Wiring Harness Length 8 FT